| Contact us |
 |
ADD：NO.20 Yayao Middle Road Yayao Town Huadu District Guandzhou City
Phone：+86-13728008836
Tel：020-89680952
Fax：020-89680951
Mail: taisheng@gdtsindustry.com
|
|
|
|
|
| Home > Service |
|
Elements need to pay attention to the water-based printing slotting die-cutting machine adjustment in
post time: 2013-5-7 | hits: 882 |
Printing slotting die-cutting machine parts of introduction and modification of the standard
Paper feeding part
The front baffle - gap is set to 1.5 times the thickness of cardboard, distance zone.
Side baffle - by patting plate side dimension 2mm.
Beat together board - shoot Qi shot into the side baffle plate 5mm.
Plate, front plate and rear apron is less 2mm, lower than 2mm.
Suction table - in speed paper size and the bending degree adjustment of air volume.
Kick the claw plate - back 0 point play paper enters after the file version of the 5-8mm.
Front paper - suction quantity in accordance with the speed adjustment, rear apron board seat lifting adjustment according to the bending degree.
Paper feeding roller - gap adjustment by the paper feeding wheel after crushing pressure shall not exceed 0.1mm.
The printing department
Rubber roller - also called the scraping roller; each time and the pattern roller clearance adjustment to the same and light printing hue to the same.
Wipe clean to scraping knife - blade after cleaning.
Roll pattern - parallelism to accurately, and print to touch and to try to near the 0 - point, without access to the printing plate pad.
A printing plate roller - hanging version line to align, firmly and transverse to zero, the printing roller to clean.
Embossing roller - gap set with light pressure, can avoid gain produce waves mark fine words is not clear, the full version of hollow words double shadow, its printing crushing is not restricted.
Pull wheel - size at least press paper edge more than 10mm, the gap to height line thickness under the pressure of 0.3mm - -0.6mm, each color and color 0.1mm less than before.
The air sucking and conveying - in accordance with the paper size open suction vacuum air gate, paper size, speed adjustment.
Slot Department
Preloading roller - gap should be less than half the board thickness is not broken the principle.
Line pressing roller - gap is about half the crushing roller so as not to break the principle.
Slotted knife, knife knife cut must be accurate, upper base and the lower base paste foam slip.
Trimming knife, knife knife contact above 10mm, to the vertical sealing.
Back rolling Department
Draw rollers - set value transmission side into the edge of the paper to the 10mm, the operating side
A knife inside 10mm.
Start with base point rolling die cylinder - loaded rolling mode, the computer setting electric adjustment
Rolling die pad - commissioning time gap should be light, slowly rolling pressure required to.
Folding Department
Folding arm - entrance in the board thickness adjustment, two dimension AB Leng less 2mm
A type 1mm B type less, according to the original size.
Paste reel - divided into paste and paste spraying type wheel.
Out of paper
Forming groove - according to the carton size correction assembly.
|
|
|
